3 L4-2.0L (2007)
Crankshaft Pulley Lock Bolt Removal Note
1. Remove the cylinder block lower blind plug.
2. Install the SST.
3. Turn the crankshaft clockwise the crankshaft is in the No.1 cylinder TDC position (until the balance weight is attached to the SST).
4. Hold the crankshaft pulley using the SSTs.
No.3 Engine Mount Rubber Removal Note
1. To install the front shaft (RH) of the SST (49 C017 5A0), remove the clip shown the figure.
