3 L4-2.0L (2007)
Note: The TWC installation nut should remain untightened.
(3) Replace the gasket with a new one and install the new TWC to the WU-TWC.
Note: The U-shaped bolt can be inserted to the pipe on either side.
(4) Insert the U-shaped bolt.
(5) Insert the TWC to the presilencer, and align the cut surface of the pipe with the marking.
7. Tighten the TWC installation nut.
8. Tighten the U-shaped bolt between the presilencer and the new TWC using the following procedure. (Cut location A)
Note: The TWC has a marked line at the specified position where the U-shaped bolt is to be set.
(1) Set the U-shaped bolt in the specified position.