3 L4-2.0L (2007)
(2) Set the U-shaped bolt so that the clearance between the bolt and surrounding parts is as indicated in the figure.
Caution:
^
Do not loosen U-shaped bolt after tightening. If it is loosened, the bolt cannot be tightened at the specified torque with the specified
protrusion.
^
Tighten the U-shaped bolt in three or four steps, left and right equally, to prevent clamp deformation.
(3) Tighten the U-shaped bolt.
Protrusion of U-shaped bolt after tightening 17 - 19 mm (0.67 - 0.74 in)
Except for California Emission Regulation Applicable Model
Note: The TWC is integrated with the presilencer and main silencer. Therefore, when replacing the TWC, cut between the TWC and presilencer.
Cut Location
1. Remove the rear tunnel member.
2. Remove the front tunnel member.
Caution: Be careful not to deform the pipe when cutting. If the pipe is deformed, the new pipe may not be installed correctly.
3. Cut the pipe between the TWC and presilencer using the following procedure. (Cut location A)