3 L4-2.5L (2010)
Drive Belt: Service and Repair
DRIVE BELT REMOVAL/INSTALLATION [LF, L5]
LF
A/C drive belt removal
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit. See: Body and Frame/Splash Guard/Service and
Repair/Aerodynamic Under Cover No.2 Removal/Installation See: Body and Frame/Splash Guard/Service and Repair/Splash Shield
Removal/Installation
2. Remove the nut shown in the figure and set the power steering pipe component out of the way.
3. Set the SST as shown in the figure.
NOTE:
-
Hold the SST by hand until it fits between the A/C drive belt and the crankshaft pulley.
4. Rotate the crankshaft pulley clockwise using a wrench and remove the A/C drive belt.
A/C drive belt installation
1. Set the SST to the crankshaft pulley as shown in the figure.
NOTE:
-
Hang the A/C drive belt on to the A/C compressor pulley, then move the SST upward along the crankshaft pulley.