6 L4-2.5L (2010)
NOTE:
-
The quick release connector can be removed by pushing the center of the retainer tabs.
-
The retainer is attached to the fuel pipe even after the connector is disconnected.
3. Hold the center of the retainer tabs with the SST ends and press the retainer.
4. Pull the connector side and disconnect the quick release connector.
5. Raise a retainer tab using the SST and remove the retainer.
6. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
When using SST 49 N013 103A (Part of 49 N013 1A0D)
1. Complete the "BEFORE SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/Before Service Precaution
2. Insert the SST into the quick release connector.
