6 L4-2.5L (2010)
2. Partially peel back the seaming welt.
3. Remove the C-pillar trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/C-Pillar Trim Removal/Installation
4. Disconnect the curtain air bag module connector.
5. Connect the SST (Deployment tool) to the SST (Adapter harness).
6. Connect the SST (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the
negative battery terminal.
7. Verify that the red lamp on the SST (Deployment tool) is illuminated.
8. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
9. Press the activation switch on the SST (Deployment tool) to operate (deploy) the curtain air bag module.
WARNING:
-
The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do not touch the air bag module for at least 15
min after deployment.
10. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
Pre-tensioner Seat Belt
1. Remove the front scuff plate. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate
Removal/Installation
2. Remove the rear scuff plate. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Rear Scuff Plate Removal/Installation
3. Remove the B-pillar lower trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Lower Trim
Removal/Installation
4. Remove the pre-tensioner seat belt and connect the SST (Adapter harness) as shown in the figure. See: Seat Belt Systems/Seat Belt/Service and
