6 L4-2.5L (2010)
9. Remove the hook A.
10. Pull the passenger-side air bag module in the direction of arrow (1) and detach the hook A from the instrument panel.
11. Press the passenger-side air bag module in the direction of arrow (2) and rotate it in the direction of arrow (3) and remove it.
12. Install in the reverse order of removal.
13. Switch the ignition to ON.
14. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the
system. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Flowchart
Side Air Bag Module Removal/Installation
SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
-
Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag
system service warnings and cautions before handling the air bag module. See: Service Precautions/Air Bag System Service Warnings See:
Service Precautions/Air Bag System Service Cautions
-
If the side air bag module is installed with debris in the seat back, the foreign material may be scattered when the side air bag module operates
(deploys), causing injury. Verify that there is no foreign material in the seat back before installing the side air bag module.
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the front seat. See: Body and Frame/Seats/Service and Repair/Removal and Replacement
4. Remove the seat back trim and the seat back pad. See: Body and Frame/Seats/Seat Back/Service and Repair/Removal and Replacement
5. Disconnect the clip A, B from the front seat.
