B2300 L4-2.3L (2008)
4. Move the steering gear as far to the RH side of the vehicle as possible.
5. Move the LH inner tie rod into the opening in the crossmember and move the steering gear into position.
6. To place the steering gear in the straight-ahead position, turn the steering gear input shaft to the left by 1/2 the number of turns previously
recorded.
7. Rotate the steering gear control valve housing toward the rear of the vehicle.
8. Install the 2 steering gear stud bolts.
Caution:
^
Hold the tops of the steering gear-to-crossmember stud bolts to avoid damaging the steering gear fluid transfer tubes.
9. Install the 2 steering gear nuts.
^
Tighten to 150 Nm (15.3 kgf-m, 111 ft-lbf).
Note:
^
New O-ring seals must be installed any time the lines are disconnected from the steering gear or a fluid leak may occur.
10. Position the pressure and return lines and install the steering line clamp plate nut.
^
Tighten to 35 Nm (3.6 kgf-m, 26 ft-lbf).
Caution:
^
Do not allow the steering column shaft to rotate while it is disconnected from the steering gear or damage to the clock-spring can
