B2300 L4-2.3L (2008)
Front Steering Knuckle: Service and Repair
Wheel Knuckle
WHEEL KNUCKLE
Removal and Installation
Caution:
^
Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary.
Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to
make sure of correct retention of these parts.
1. Remove the wheel bearing and wheel hub assembly.
2. Remove the wheel speed sensor harness bolt.
Tightening Torque:
15 Nm (1.5 kgf-m, 11 ft-lbf)
3. Remove the outer tie-rod end nut.
Tightening Torque:
80 Nm (8.2 kgf-m, 59 ft-lbf)
^
Install a new cotter pin.