B2300 L4-2.3L (2008)
12. Remove the manual valve inner lever and parking lever actuating rod.
13. Remove the rear propeller shaft.
14. If equipped, remove the transfer case.
Note:
^
If damage is found to the parking gear, the transmission must be removed and disassembled.
The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.
15. Remove the extension housing. Discard the extension housing gasket.
16. Inspect the parking pawl, parking pawl return spring and the parking pawl shaft. Replace if required.
Installation
Caution:
^
Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Verify that the output shaft is
locked in the PARK position.
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
Caution:
^
Do not bend the manual valve inner lever pin.
