B2300 SE Regular Cab 2WD L4-2.3L VIN D (2001)
5.
Remove the quad seal.
6.
Install the new quad seal(s) from the kit.
7.
Re-install the hydraulic fitting to the Clutch Master Cylinder and/or Clutch Slave Cylinder:
8.
Install the roll pin(s) using the hammer and 1/8" punch.
9.
Insert a cotter pin through the center of the newly installed roll pin(s) and bend to secure.
10.
Truck: Bench Bleed the Clutch Master Cylinder according to the Workshop Manual (section 05-10 CLUTCH BLEED PROCEDURE BENCH).
11.
Reinstall the Clutch Master Cylinder and/or external Clutch Slave Cylinder according to the Workshop Manual (section 05-10 CLUTCH).
12.
Bleed the clutch system on the vehicle:
-
Truck: The quick connect coupler should make it unnecessary to bleed the clutch circuit on the vehicle, however, if you have clutch apply
concerns refer to the Workshop Manual (section 05-10 CLUTCH)
-
Tribute: bleed the clutch system on the vehicle according to the Workshop Manual (section 05-10 CLUTCH)
13.
Verify repair
PART(S) INFORMATION
WARRANTY INFORMATION
Note:
This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term
information.
DISCLAIMER