B3000 V6-3.0L (2007)
Band Apply Servo: Service and Repair
Reverse Servo Assembly Removal / Installation
REVERSE SERVO ASSEMBLY REMOVAL / INSTALLATION
Removal Note
1. Drain the transmission fluid.
2. Remove the bolt.
3. Remove the oil strainer.
4. Remove the bolts.
5. Remove the reverse band servo cover and gasket. Discard the reverse servo separator plate cover gasket.
6. Remove the reverse band servo piston and rod and the reverse servo piston return spring.
Installation Note
1. Clean and inspect the reverse servo piston bore and the reverse band servo piston and rod.
2. Install the reverse band servo piston and rod into the servo bore along with a reverse servo return spring.
3. Install the servo rod selecting gauge SST.
(1) Install a new reverse servo separator plate cover gasket.
(2) Tighten the three screws.