B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
9. Remove the manual lever shaft seal.
Installation Note
1. Use Shift Lever Seal Replacer T74P-77498-A or equivalent to install the manual lever shaft seal.
1. Lubricate the manual control lever shaft seal with petroleum jelly.
2. Install the manual control lever shaft.
Caution Use care not to damage the fluid pan rail surface when installing the retaining pin.
3. Align the manual control lever shaft alignment groove with the manual control lever shaft spring pin bore in the transmission case.
1. Tap the manual control lever shaft spring pin into the transmission case.
4. Align flats of the manual valve inner lever with flats on the manual control lever shaft. Install the manual valve inner lever and parking lever
