B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
actuating rod onto the manual control lever shaft.
Caution Do not bend the manual valve inner lever pin.
5. Install the manual valve inner lever nut.
Caution Park pawl actuating rod must be properly installed into parking pawl and guide cup located in extension housing. Verify park linkage
function.
6. Verify that the output shaft is locked in the PARK position.
7. Install the transmission fluid pan with new pan gasket.
8. Install the digital TR sensor. Refer to Powertrain Manangement; Computers and Control Systems; Transmission Position Switch/Sensor.
9. Lower the vehicle.
10. Connect the battery ground cable.
11. Fill the transmission to the proper fluid level.