B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
7. Position a Dial Indicator/Magnetic Base as shown. Turn the Companion Flange Runout Gauge SST 205-319 (T92L-4851-B) and locate and mark
the high spot on the flange with yellow paint.
If the flange runout exceeds 0.25 mm (0.010 inch), remove the flange, reindex the flange one-half turn on the pinion, and reinstall it.
8. Check the runout again. if necessary, rotate the flange until an acceptable runout is obtained. If the flange runout is still more than 0.25 mm (0.010
inch), replace the companion flange.
9. If excessive runout is still evident after replacement of the flange, replace the ring and pinion. Repeat the above checks until the runout is within
specifications.
10. Install the propeller shaft.
