Mazdaspeed6 L4-2.3L Turbo (2006)
3. Slide the A-pillar trim in the direction of the arrow shown in the figure and remove the A-pillar trim from clip B.
4. Rotate and pull clip B in the direction of the arrow shown in the figure until it is no longer loose, and feels tight.
5. Pull clip B and remove it from the grommet.
6. Insert a tape-wrapped flathead screwdriver between the body and the grommet.
7. Press the tabs and remove the grommet.
8. Install the new grommet to the body.
9. Install the new clip B to the A-pillar trim.
10. Install the A-pillar trim.
B-Pillar Lower Trim Removal/Installation
B-PILLAR LOWER TRIM REMOVAL/INSTALLATION
1. Remove the front scuff plate.
2. Remove the rear scuff plate.
3. Pull the area marked A, then remove one side of the B-pillar lower trim.
