Mazdaspeed6 L4-2.3L Turbo (2006)
Fluid - A/T: Service and Repair
Automatic Transaxle Fluid (ATF) Replacement [AW6A-EL]
AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6A-EL]
Warning:
^
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
1. Disconnect the negative battery cable.
2. Remove the oil dipstick.
3. Remove the air cleaner component.
4. Remove the oil filler plug and O-ring.
5. Remove the under cover.
6. Remove the oil drain plug and gasket.
7. Drain the ATF into a container.
8. Install a new gasket and the drain plug.
Tightening torque 23.5 - 54.9 Nm (2.4 - 5.5 kgf.m, 17.4 - 40.4 ft. lbs.)
9. Add the specified ATF through the oil filler plug until it reaches the lower notch of dipstick.
ATF Type: JWS3309
Capacity (Approximately quantity): 7.0 Liters (7.4 US quarts, 6.2 Imp quarts)
10. Install a new O-ring and the filler plug.
Tightening torque 23.5 - 54.9 Nm (2.4 - 5.5 kgf.m, 17.4 - 40.4 ft. lbs.)
11. Install the under cover.
12. Install the air cleaner component.
13. Connect the negative battery cable.
14. Ensure that the ATF level is in the HOT range 65°C (149 °F).
^
Add ATF to the specified level as necessary.
