Mazdaspeed6 L4-23L Turbo (2006) Automatic Transmission Fluid Pressure Sensor Location
7. Verify that there is continuity between oil pressure switch terminal and ground.
^
If not as specified, replace the oil pressure switch.
8. Connect the oil pressure switch connector.
9. Install the under, cover.
10. Connect the negative battery cable.
Off-vehicle inspection
1. Remove the oil pressure switch.
2. Apply air pressure at 400 - 440 kPa (4.1 - 4.4 kgf/cm2, 58 - 63 psi)
3. Inspect continuity the between oil pressure switch terminal and screw part.
^
If not as continuity, replace the oil pressure switch.
4. Install the oil pressure switch.