Mazdaspeed6 L4-2.3L Turbo (2006)
Note:
^
Install the selector lever to the manual shaft lever with the clip side of the selector cable end facing up.
7. Install the selector lever to the manual shaft lever so that no load acts on the selector cable.
8. Confirm that the tip of the manual shaft lever projects out of the end of the selector cable.
9. Securely install the selector cable to the selector cable bracket.
Interlock Cable Installation Note
1. Install the interlock cable as shown in the figure.
Caution:
^
Position the sponge protector so that it is not crushed or squeezed by the SAS control module.
^
If the interlock and selector cables cross over each other, position the interlock cable to pass over the selector cable.
2. Push the interlock cable.
3. Verify that the marking on the slider pin is positioned as shown in the figure.
