Mazdaspeed6 L4-2.3L Turbo (2006)
4. Push the a 1.5 mm (0.059 inch) round bar or similar into hole A by fully pushing the slider pin in.
5. Fully pull the end of the interlock cable.
6. Push the a 1.5 mm (0.059 inch) round bar or similar into hole B and hole C of the lock unit until it passes through.
7. Disconnect the brake switch connector.
8. Remove the brake switch.
9. Install a new brake switch.
Caution:
^
Do not connect the brake switch connector until the interlock cable is installed.
10. With the slider pin pressed, slide the lock unit to fix the lock unit hook into the bracket hole securely as shown in the figure.
Caution:
^
Allowing the interlock cable to be bent or twisted during installation can affect the lock unit operation.
11. Rotate the slider pin to release the lock and verify that it slides freely
