Mazdaspeed6 L4-2.3L Turbo (2006)
12. Pull the slider pin outward until it contacts the brake pedal stopper rubber and rotate the slider pin to lock.
13. Verify that the selector lever in the P position.
14. Install the interlock cable end to the cam pin on the selector lever.
15. Fit the interlock cable in the U-groove in the selector lever base plate and install the clip.
16. Press the interlock cable lock piece in until it is locked.
Caution:
^
Applying a load to the interlock cable while pressing the lock piece in can affect the lock unit operation.
17. Remove the a 1.5 mm (0.059 inch) round bar or similar from the lock unit holes A, B, and C.
18. Connect the brake switch connector with the brake pedal released.
