Mazdaspeed6 L4-2.3L Turbo (2006)
Valve Body: Service and Repair
Primary Control Valve Body Removal [FS5A-EL]
PRIMARY CONTROL VALVE BODY REMOVAL [FS5A-EL]
On-Vehicle Removal
Warning:
^
Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyes whenever using
compressed air.
Caution:
^
Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents before removal.
^
If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan. Clean with cleaning
fluids.
1. Disconnect the negative battery cable.
2. Drain the ATF into a separate suitable container.
3. Remove the under cover.
4. Remove the front tires and splash shield.
5. Remove the crossmember.
6. Remove the oil pan.
7. Disconnect the solenoid connectors and GND.
8. Remove the oil strainer.
9. Remove the primary control valve body installation bolts as shown, then remove the primary control valve body component as shown.
10. Remove the accumulators and accumulator springs.
