Mazdaspeed6 L4-2.3L Turbo (2006)
16. Fix the coupler component with tape to the transaxle case as shown in the figure.
17. Remove the VSS connector and input/turbine speed sensor connector from the solenoid clamp.
Note:
^
Be sure to secure the VSS and input/turbine speed sensor with tape so that they will not interfere with the control valve body component.
18. Fix the VSS wiring harness and input/turbine speed sensor wiring harness with tape to the transaxle case as shown in the figure.
19. Remove the suction cover and the gasket.
Caution:
^
Evenly loosen the bolts a little at a time in the order shown in the figure.
