Mazdaspeed6 L4-2.3L Turbo (2006)
Caution:
^
Do not mark with a punch to prevent imbalance.
1. Before removing the nut, place alignment marks on the companion flange (front) and constant velocity joint, and on the companion flange (rear)
and yoke.
Propeller Shaft Installation Note
1. Align the alignment marks and install the propeller shaft.
2. When installing a new propeller shaft, align the rear differential companion flange mark with the tag on the propeller shaft so that they are at the
nearest position, and assemble.
3. Perform a road test and verify that there is no abnormal vibration or noise.
Propeller Shaft Heat Shield Installation Note
Caution:
^
The serviceability may be negatively affected if the bolt hole is blocked when assembling the propeller shaft heat shield to the bearing support.
When assembling, be careful that the rim of the propeller shaft heat shield bolt hole does not cover the bearing support bolt hole.
