Mazdaspeed6 L4-2.3L Turbo (2006)
Flywheel: Testing and Inspection
Flywheel Inspection [A26MX-R]
FLYWHEEL INSPECTION [A26MX-R]
Caution:
^
Do not rework the flywheel if it is distorted.
^
Do not clean the dual mass flywheel with any kind of fluid. Clean the flywheel with a dry cloth only.
^
Do not clean the gap between the primary and secondary mass. Only clean the bolt connection surface and the clutch surface.
1. Remove the flywheel.
Note:
^
Correct slight scratches and discoloration using sandpaper.
^
Inspect the runout of the surface that contacts the clutch disc with the flywheel installed to the crankshaft.
2. Inspect the flywheel.
-
Cracks
-
Worn ring gear teeth
-
Chipped or cracked ring gear teeth
-
Surface that contacts the clutch disc for scratches, nicks, and discoloration.
^
If there is any malfunction, replace the flywheel.
3. Inspect the flywheel for lateral movement.
1) Rotate the flywheel in either or both directions, or rock slightly on the axis in relation to the primary mass.
-
If there is any lateral movement, replace the flywheel with a new one.
4. Verify that the secondary mass does not rotate by 15 teeth or more.
^
If it rotates by 15 teeth or more, replace the dual-mass flywheel.
5. Visually inspect the secondary mass.
^
If there is any damage, replace the dual-mass flywheel.
