Mazdaspeed6 L4-2.3L Turbo (2006)
Seals and Gaskets: Service and Repair
Oil Seal (Differential) Replacement [A65M-R]
OIL SEAL (DIFFERENTIAL) REPLACEMENT [A65M-R]
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Drain the oil from the transaxle.
3. Remove the front wheels and splash shields.
4. Separate the drive shaft and joint shaft from the transaxle.
5. Remove the oil Seals using a screwdriver.
6. Using the SSTs and a hammer, tap each new oil seal in evenly until the SSTs contact the transaxle case.
7. Coat the lip of each oil seal with transaxle oil.
8. Insert the drive shaft and joint shaft into the transaxle.
9. Install the wheels and splash shields.
10. Add the specified amount and type of oil.
