Mazdaspeed6 L4-2.3L Turbo (2006)
Control Module: Testing and Inspection
TCM Inspection [FS5A-EL]
TCM INSPECTION [FS5A-EL]
Caution:
^
The TCM terminal voltages vary with changes in measuring and vehicle conditions. Always carry out a total inspection of the input and output
systems, and the TCM to determine the cause of trouble. Otherwise, a mis-diagnosis could occur.
1. Measure the voltage at each terminal.
^
If any incorrect voltage is detected, inspect the related system(s), wiring harnesses and connector(s) referring to the Action column in the
terminal voltage table.
Terminal Voltage Table (Reference)
Note:
^
Use the ground of terminal 10 and 1P of the TCM when measuring terminal voltage, as an error may occur when connecting the negative circuit
tester to ground.