MPV DX V6-2.5L DOHC (2000)
Fuel Injector: Testing and Inspection
Injector Volume Test
WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Always carry out the
following procedure with the engine stopped.
NOTE:
-
If there is an after market fuel injector tester, perform the following test.
-
If there is no an after market fuel injector tester, perform "Simulation Test" "Resistance Inspection", and "Fuel Leakage Test" to verify the fuel
injector is okay or not.
1. Complete the "BEFORE REPAIR PROCEDURE".
2. Disconnect the negative battery cable.
3. Remove the fuel injectors.
4. Connect the fuel injector to the fuel injector tester.
5. Measure the injection volume of each fuel injector using a graduated container.
-
If rot as specified, replace the fuel injector.
Injection volume
44 - 58 ml {44 - 58 cc, 1.5 - 1.9 fl oz}/15 sec.
6. Turn the ignition switch to LOCK position and disconnect the jumper wire.
7. Complete the "AFTER REPAIR PROCEDURE".
