MPV ES 4WD V6-3.0L SOHC (1997)
Passenger-side Air Bag Module Installation
1. Connect the leads of the SST to terminals A and B of the clock spring connector.
2. Set the resistance of the SST to 2 ohms.
3. Connect the negative battery cable.
4. Turn the ignition switch to ON.
5. Verify that air bag system warning light illuminates for approximately 6 seconds and then goes off.
6. Verify that diagnostic trouble code 7 is set.
7. If another diagnostic trouble code is set, perform the appropriate AIR BAG SYSTEM ON-BOARD DIAGNOSIS.
8. If diagnostic trouble code 7 is set, turn the ignition switch to LOCK.
9. Disconnect the negative battery cable and wait for more than one minute to allow the backup power supply to deplete its stored power.
Passenger-side Air Bag Module Installation
Passenger-side Air Bag Module Installation
10. Install in the order indicated in the table.
11. Carry out the "After Servicing" procedure.
