MPV ES 4WD V6-3.0L SOHC (1997)
Air Bag: Service and Repair
Removal and Installation
Driver-Side Air Bag Module Removal
WARNING: Handling the air bag module improperly can accidently deploy the air bag, which may seriously injure you. Read AIR BAG
SYSTEM SERVICE WARNINGS before handling the air bag module.
1. Carry out the "Before Servicing" procedure.
Driver-Side Air Bag Module Removal
2. Remove in the order indicated in the table.
Driver-Side Air Bag Module Installation
WARNING:
^
Handling the air bag module improperly can accidently deploy the air bag, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the air bag module.
^
Installing the driver-side air bag module when diagnostic trouble code 6 is not indicated can accidently deploy the air bag, which can
cause serious injury. Carry out the proper troubleshooting procedures and verify that diagnostic trouble code 6 is indicated before
installing the driver-side air bag module.
Driver-Side Air Bag Module Installation
1. Connect the negative battery cable.
2. Turn the ignition switch to ON.
3. Verify that air bag system warning light illuminates for approximately 6 seconds and then goes off.
4. Verify that diagnostic trouble code 6 is set.
5. If another diagnostic trouble code is set, perform the appropriate AIR BAG SYSTEM ON-BOARD DIAGNOSIS.
6. If diagnostic trouble code 6 is set, turn the ignition switch to LOCK.