MPV LX 4WD V6-3.0L SOHC (1997)
3. Install the timing belt cover.
^
Install the timing belt covers along with new gaskets.
^
Tighten the bolts in the order shown.
Tightening torque:
M6: 7.9-10.7 Nm (70-95 in lbs.)
M10: 38-51 Nm (28-38 ft. lbs.)
4. Install the crankshaft pulley.
a. Install the crankshaft pulley and hand tighten the pulley lock bolt.
CAUTION: The crankshaft position sensor rotor is on the rear of the crankshaft pulley, and can be damaged easily.
b. Mount SST# 49 S120 710 on the crankshaft pulley to hold the crankshaft.
c. Tighten the crankshaft pulley lock bolt.
Tightening torque: 157-166 Nm (116-122 ft lbs.)
5. Install the upper radiator hose and coolant bypass hose.
6. Install the A/C compressor idler pulley.
7. Install the drive belts.
8. Install the cooling fan and radiator cowling.
9. Install the fresh air duct.
10. Install the high tension lead wires and the spark plugs.
11. Fill the radiator and coolant reservoir with the specified amount and type of engine coolant.
12. Connect the negative battery cable.
13. Start the engine and check the following:
^
check the engine oil and engine coolant leakage.
^
check the ignition timing and idle speed.
