MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
mounting rubber end and steel pipe are aligned.
Oil Seal, Inner Guide Assembly Note
1. Install a new O-ring and new seal ring to the rack's piston.
2. After installing the seal ring, seat it properly at the piston circumference.
3. Install a new oil seal and inner guide to the SST.
4. Using the SST, place the oil seal and inner guide at the edge of the steering rack's pinion, and remove the SST.
5. After mounting the steering rack to the gear housing, use a press to install the oil seal and inner guide to the correct position.
Caution:
^
When pressing in, do not apply a load pressure of more than 39,227 kPa (400 kgf/cm2, 5,688 psi).
^
Doing so will damage the oil seal and inner guide.
^
Apply grease to the seal ring, oil seal and inner guide.
Holder Assembly Note
1. Apply grease to the U-gasket and O-ring.
2. Assemble the U-gasket and O-ring into the holder.
3. Assemble the holder using the SST.
4. Stake the holder to the cylinder using a punch.
Oil Seal Assembly Note
1. Apply grease to a new oil seal.
