MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
2. Place a chisel against the boot and hold it at the angle shown.
3. Remove the boot by tapping it with a hammer.
Tie-rod End Boot Assembly Note
1. Wipe the grease off the ball joint.
2. Put a small amount of lithium-based grease into a new dust boot.
3. Install the dust boot onto the tie-rod end using the SST and a press.
4. Wipe away any excessive grease.
Mounting Rubber Assembly Note
1. Apply soapy water to the rubber part of the mounting rubber.
2. Press the mounting rubber until the mounting rubber end comes out completely from the gear housing using the SSTs and a press.
3. Reverse the gear housing, then press the mounting rubber until the mounting rubber end comes out completely from the other side. At this time,