Protege LX L4-1489cc 1.5L DOHC MFI (1998)
4. Securely bond spacer B to the glass as shown.
5. Install spacers A. If a spacer is damaged, replace it.
6. Temporarily install the glass onto the body and adjust the glass-to-body clearance.
7. Make a mark on the glass directly above the V-notch of spacers A.
8. Remove the glass.
9. Apply primer onto the bonding area of the glass and body by using a brush. Use only glass primer on the glass and body primer on the body. keep
the area free of dirt and grease, and do not touch the surface. Allow the primer to dry for approximately 30 minutes.
10. Apply an 11 mm {O.43 in} high bead of sealant around the circumference of the glass as shown. Keep the bead of sealant smooth and even,
reshaping it with a spatula where necessary. If the windshield is being reused, apply new sealant over the original.
11. Align the glass marks with the V-notches of spacers A and install the glass onto the body.
