RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
Tightening torque: 7.8 - 11 N-m (80 - 110 cm-kg, 69 - 95 in-lb)
4. Install the control lever and control rod end.
CAUTION: The roll pin should be installed so that the seam of the pin face as shown in the image.
5. Install a new roll pin into the control lever end.
NOTE: Align the inner shift lever and shift rod end groove.
6. Apply sealant to the contact surfaces of the extension housing and bearing housing.
7. Turn the control rod in the direction of the arrow and install the extension housing.
8. Apply sealant to the bolt threads, then install the bolts
Tightening torque:
(A): 41 - 55 N-m (4.2 - 5.6 m-kg, 30 - 41 ft-lb)
(B): 31 - 46 N-m (3.2 - 4.7 m-kg, 23 - 34 ft-lb)
9. Install the select-lock spindle, spring, and spring cap.
Tightening torque: 7.8 - 11 N-m (80 - 110 cm-kg, 69 - 95 in-lb)
