Tribute 2WD V6-3.0L (2008)
Air Bag Control Module: Service and Repair
RESTRAINTS CONTROL MODULE (RCM) REMOVAL/INSTALLATION
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
The restraints control module (RCM) orientation is critical for correct air bag SRS operation. If a vehicle equipped with an SRS system
has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting and bracket for deformation. If
damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure the area of the RCM is restored
to its original condition.
-
Do not handle, move or change the original horizontal mounting position of the RCM while the RCM is connected and the ignition switch
is ON. Failure to follow these instructions may result in the inadvertent deployment of the safety canopy and risk of personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION:
-
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
-
When installing a new restraints control module (RCM), it is necessary to carry out programmable module installation (PMI). See
MODULE CONFIGURATION. See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and Relearning Failure to
follow these instructions may result in vehicle damage, equipment damage, component damage and/or system failure.
NOTE:
-
When installing a new RCM, always make sure the correct RCM is being installed. If an incorrect RCM is installed, erroneous DTCs will result.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. If installing a new restraints control module (RCM), carry out the steps necessary to prepare for programmable module installation (PMI). See
MODULE CONFIGURATION. See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and Relearning
2. Depower the system. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
3. Remove the floor center console.
4. Remove the lower LH center instrument panel finish panel.
