Tribute 2WD V6-3.0L (2008)
1. Separate the weatherstrip.
2. Pull out and separate the quarter trim panel at the D-pillar trim panel.
3. Pull out to release the retainers and remove the D-pillar trim panel.
18. Disconnect the driver side safety canopy module electrical connector.
19. From under the rear of the driver seat, slide and disengage the driver seat side air bag module electrical connector locking clip, and then release
the tab and disconnect the driver seat side air bag module electrical connector.
20. Install RCM fuse 32 (10 A) to the SPDJB.
21. Connect the battery ground cable. See BATTERY DISCONNECT.
Reactivation
22. Remove RCM fuse 32 (10 A) from the SPDJB.
23. Disconnect the battery ground cable and wait at least one minute. See BATTERY DISCONNECT.
