Tribute 2WD V6-3.0L (2008)
NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must be aligned correctly when installed.
10. Separate the hook-and-loop fasteners and remove the seat backrest trim cover.
CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
11. Remove the backrest foam pad from the backrest frame.
12. Release the seat latch cable from the retractor.
13. Remove the 2 nuts and the safety belt guide.
-
To install, tighten to 40 N.m (4.1 kgf.m, 30 ft.lbf).
14. Remove the nut and the rear center safety belt retractor.
-
To install, tighten to 40 N.m (4.1 kgf.m, 30 ft.lbf).
15. To install, reverse the removal procedure.
16. Check the active restraint system for correct operation.
-
Make sure that after the rear safety belt retractor is installed, the retractor is not in the automatic locking retractor (AIR) mode. See
OCCUPANT RESTRAINT SYSTEM.
