Tribute 2WD V6-3.0L (2008)
Removal/Installation
WARNING:
-
All safety belt assemblies (including retractors, belt tension sensor [BTS], if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use
during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow
these instructions could increase the risk of serious personal injury in collisions.
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in serious personal injury.
-
To reduce the risk of serious personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All Seats
1. Depower the SRS. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
2. Remove the affected seat from the vehicle.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sifting on a seat not secured in the vehicle
may result in damaged components.
3. Remove the inboard seat cushion side shield.
-
Remove the 2 cushion side shield screws.
