Tribute 2WD V6-3.0L (2008)
NOTE:
-
To identify between a production OCS system and a service OCS system (OCS service kit), inspect the ECU electrical connector. A production
OCS system allows the disconnect of the ECU electrical connector. A service OCS system (OCS service kit) has the ECU electrical connector
glued to the ECU. It cannot and should not be disconnected or altered.
-
If removing an OCS service kit, refer to the appropriate procedure in this section.
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate an SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Depower the system. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
2. Remove the passenger seat.
3. Disconnect the electrical connectors and wiring clips.
