Tribute 4WD L4-2.5L Hybrid (2009)
Hose/Line HVAC: Service and Repair
Condenser To Receiver Drier Line Removal/Installation
CONDENSER TO RECEIVER DRIER LINE REMOVAL/INSTALLATION
NOTE:Installation of a new receiver/drier is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the receiver/drier.
1. Recover the refrigerant. See See: Heating and Air Conditioning/Service and Repair/Discharging And Recovery.
2. Remove the front bumper cover. See See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair.
3. Remove the condenser-to-suction accumulator line bracket nut.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
4. Remove the compressor manifold and tube bracket nut.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
5. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
