Tribute 4WD L4-2.5L Hybrid (2009)
Installation
1. Align the coil spring and coil spring insulator to the previously noted position.
2. Using a suitable jackstand, carefully raise the wheel knuckle.
3. Install the new shock absorber lower bolt, washer and nut.
-
Tighten to 175 Nm {18 kgf-m, 121 ft-lbf}.
4. Install the upper arm. See See: Control Arm/Service and Repair/Upper Arm Removal/Installation [Rear Suspension].
5. Connect the brake tube fitting to the wheel cylinder.
-
Tighten to 17 Nm {1.7 kgf-m, 150 in-lbf}.
6. Install the brake tube bracket bolt.
-
Tighten to 22 Nm {2.2 kgf-m, 16 ft-lbf}.
7. Install the brake hose bracket-to-wheel knuckle bolt.
-
Tighten to 22 Nm {2.2 kgf-m, 16 ft-lbf}.
8. Bleed the rear wheel cylinder. See See: Brakes and Traction Control/Brake Bleeding/Service and Repair/Brake System Bleeding.