Tribute 4WD L4-2.5L Hybrid (2009)
Suspension Spring ( Coil / Leaf ): Removal and Replacement
Strut And Spring - Front Removal/Installation [Front Suspension]
-
STRUT AND SPRING - FRONT REMOVAL/INSTALLATION
NOTE:LH side shown, RH side similar.
Removal
CAUTION:Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major
service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of
lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct retention of these parts.
1. Remove the wheel and tire. See See: Wheels and Tires/Wheels/Service and Repair.
NOTE:Verify the steering wheel is in the unlocked position before removal.
2. Remove the brake jounce hose clip.
3. Pull the brake jounce hose downward slightly to remove the hose from the bracket and position the brake jounce hose aside.
4. Remove the anti-lock brake system (ABS) wheel speed sensor harness bolt.
5. Remove and discard the upper stabilizer bar link nut.
NOTE:Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.
6. Remove and discard the 2 strut-to-knuckle nuts and bolts.
7. Remove and discard the 4 strut upper bushing nuts.
NOTE:Reference mark the 4 strut upper bushing plate nuts.
8. Remove the strut and spring assembly.