Tribute 4WD L4-2.5L Hybrid (2009)
4. Remove the fill plug on the side of the transaxle.
5. Fill the transaxle with clean transaxle fluid as specified until the level reaches the bottom of the fill plug hole.
6. Install the fill plug.
-
Tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
NOTE:Clean the area around the fill plug removing transaxle fluid that may have spilled on the transaxle case.
7. Start the engine and check for correct forward and reverse operation.
NOTE:The check and fill plug is located on the left side of the transaxle near the front.
NOTE:The transaxle fluid is checked and filled by removing the fill plug and adding transaxle fluid until it runs out.
