Tribute ES 4WD V6-3.0L DOHC (2002)
Band Apply Servo: Service and Repair
Removal
Note: Servicing the intermediate/overdrive servo in the vehicle is only recommended in the event of a leak. If servicing is required due to a servo
condition, it is necessary to remove and disassemble the transaxle to inspect the intermediate/overdrive band assembly and direct clutch for damage.
1. Raise and support the vehicle.
Warning: The servo is under pressure. Servo and servo cover are under high spring force. Use caution when removing the servo cover.
Failure to follow these instructions may result in personal injury.
2. Assemble the special tool.
3. Remove the splash shield.
4. Remove the transaxle cooler line bracket bolt and position the bracket out of the way.
Caution: Do not use a screwdriver to remove the retaining ring or damage to the case may occur. Use only snap ring pliers to remove the
retaining ring.