Tribute ES 4WD V6-3.0L DOHC (2002)
5. Using the special tool, remove the servo retaining ring.
1. Install the special tool.
2. Compress the servo assembly by tightening the bolt.
3. Remove the retaining ring.
6. Remove the special tool.
7. Remove the servo cover assembly.
8. Remove the intermediate and overdrive servo piston and return spring.
9. Wipe the servo piston and the servo cover cap with a lint free cloth.
Caution: Do not clean the rubber sealing surfaces of the servo piston and the servo cover cap with cleaning solvent or damage to the sealing
surface may result.
10. Inspect the servo piston for cracks on its pressure surfaces and in the sealing area. Look for damage near the point where the servo piston is
attached to the servo rod.
11. Squeeze the servo piston lip for flexibility. If the lip feels brittle, install a new piston
12. Inspect the servo retainer spring for cracks, breaks or deformation.
Installation
Warning: Servo return spring force is very high. Failure to follow these instructions may result in personal injury.
1. Assemble the special tool.
