Tribute LX 2WD V6-3.0L DOHC (2001)
4.
Lower the driver air bag connector access cover on steering wheel and disconnect the driver air bag module electrical connector. Connect the
special tool (41 8-F468) to the steering column harness side of the driver air bag module electrical connector.
5.
Disconnect the passenger seat belt pretensioner electrical connector and connect the special tool (418-F468) to the passenger seat belt pretensioner
harness side electrical connector.
6.
Disconnect the driver seat belt pretensioner electrical connector and connect the special tool (418-F468) to the passenger seat belt pretensioner
harness side electrical connector.
(Vehicle equipped with side air bags)
7.
Disconnect the passenger seat side air bag module electrical connector located under the seat and connect the special tool (418-F470) to the
passenger seat air bag module body harness electrical connector.
8.
Disconnect the driver seat side air bag module electrical connector located under the seat and connect the special tool (418-F470) to the driver seat
air bag module body harness electrical connector.
(All Vehicles)
9.
Connect battery negative cable.
10.
Remove the front seat assembly track to floor nuts.
11.
Remove the front seat assembly.
CAUTION:
Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in
damaged components.
12.
Remove the safety belt D-ring cover and bolt.
