Tribute LX 2WD V6-3.0L DOHC (2001)
20.
Peel back water shield and position aside to gain access to latch area.
21.
Reach in with a small screwdriver and insert screwdriver into latch assembly at outside base of electrical connector below metal actuating lever
and pry up.
NOTE:
If lever will not move freely, cycle the door lock button and door handle to free lever.
22.
Open door and move glass to the up position.
CAUTION:
Be careful not to damage door panel when opening door.
23.
Remove the last screw and remove door panel.
24.
Remove front door latch according to Workshop Manual (section 09-14 SECURITY AND LOCKS).
Installation
1.
Disconnect battery negative cable and wait at least one minute.
2.
Install new latch according to Workshop Manual (section 09-14 SECURITY AND LOCKS).
