Tribute LX 2WD V6-3.0L DOHC (2001)
1.
Locate headliner areas between C and D pillar where new push-pin holes will be drilled.
2.
Cut template along the curves printed on both sides of template.
3.
Make two holes on template along the printed circles.
4.
Position the template to the headliner.
a.
Make sure arrow on template points to front of the vehicle.
b.
Align template with glass and C-pillar or D-pillar as noted on template.
c.
Fit the D-pillar side edge as noted on template and D-pillar to locate the new push-pin hole positions.
5.
Mark both left-hand and right-hand side new push-pin hole positions as noted on the template.
NOTE:
Do not drill at this point. The left hand side electrical connector and harness need to be temporarily rotated 90 degrees to prevent damage to wires,
according to following steps.
