Tribute LX 2WD V6-3.0L DOHC (2001)
9.
Install protective tubing sleeve onto 7 mm (9/32 inch) drill bit with 7-10 mm of the drill bit exposed beyond the end of the tube.
NOTE:
This sleeve must be used to prevent damage to the roof.
10.
Align drill perpendicular (90 degrees to surface of headliner) so that pin will be flush with the headliner surface.
NOTE:
Use safety glasses or goggles to protect eyes from chips when drilling holes.
11.
Drill holes using the 7 mm (9/32 inch) drill bit with protective sleeve.
12.
Remove any debris/metal shavings that have accumulated on the headliner and/or rear cargo department as a result of drilling the holes.
NOTE:
Do not insert push-pins yet.
13.
Rotate electrical connector and harness to original position.
14.
Insert new pins into holes until headliner is 2 mm (.080 inch) above glass blackout line.
NOTE:
Be careful not to pull headliner up too far. This will cause gapping at C and D pillar trim. Pushpins can be removed and reinstalled to desired length.
15.
Verify electrical function of center dome lamp, rear dome lamp, and rear wiper.
16.
Install D-pillar trim and pushpins in original locations. Make sure clips and pins are properly positioned and seated.
17.
Inspect headliner and trim positioning.
